| (Contributed by Brad Maus)
I found this tip very useful. If you're in drawing
mode and you're done formatting the screen and picked your part for placement.
But when the part comes up on the screen it is not the one you wanted,
this is what you can do:
- Viewtype: Done/return, then
Views: Delete view,pick one part,Y,enter.
- Views: Dwg Model, Dwg Model: Add model,
?, enter, repick your part, Add view.
Now you're back to where you were and
you can keep the same name for your drawing.
Back to the Index
|
Return
to: U of M Home
